If your Tecno Pova 4 LCD backlight problem, you are not alone. This is one of the most common hardware issues reported by Tecno users. In this repair guide, we will show you exactly how to fix the tecno pova 4 lcd backlight problem using a step-by-step method that has been tested and verified. Watch the full video tutorial below and follow the written steps carefully.
Is your Tecno Pova 4 screen completely dark after a drop or repair? Did the display stop showing backlight even though the phone is working?
This video covers the complete Tecno Pova 4 LCD light solution, including backlight IC, coil, and diode-level repair directly on the motherboard. Follow every step carefully to restore your display light permanently.
📱 Compatible Models:
Tecno Pova 4, Pova 4 Pro, Pova Neo 2, Pova 3
✔ LCD backlight not working after screen replacement
✔ Display totally dark but touch is responding
✔ Backlight fuse or coil blown on motherboard
✔ Backlight IC short circuit solution
✔ No display light after water damage
🔧 Jumper wire / bodge wire
🔧 Backlight IC (RT9365 or compatible)
🔧 Backlight coil / inductor
🔧 DC power supply & multimeter
🔔 Subscribe to SANYO MOBILE for daily mobile repair solutions!
🔍 Related Searches:
Tecno Pova 4 display light solution
Tecno Pova 4 backlight IC jumper
Tecno Pova 4 motherboard light problem
Tecno Pova 4 LCD not working solution
Tecno Pova 4 display dark fix
Tecno Pova 4 backlight coil repair
Tecno Pova 4 light ways jumper solution
Tecno Pova 4 screen light problem fix
#TecnoPova4 #LCDLightSolution #BacklightFix #TecnoPova4Repair #DisplayLightSolution #MobileRepair #TecnoRepair #BacklightIC #MotherboardRepair #PhoneRepair #LCDRepair #TecnoPova4Pro #DisplayNotWorking #MobileSolution #SanyoMobile
How to Fix Tecno Pova 4 LCD backlight problem — Step-by-Step Guide
- Power off the phone and open the back cover carefully.
- Disconnect the battery to avoid short circuits.
- Locate the display flex cable and re-seat it on the motherboard connector.
- Inspect the backlight filter/coil on the board under magnification.
- Check the backlight diode and replace if burned out.
- Test the backlight LED strip using a multimeter in diode mode.
- If the backlight IC is faulty, reball or replace it with proper BGA soldering equipment.
- Reassemble and test before closing the device.
Tools You May Need
- Screwdriver set (Phillips & Pentalobe)
- Plastic pry tool / spudger
- Tweezers
- Multimeter (for advanced diagnosis)
- Soldering iron (if board-level repair is needed)
Important Tips Before You Start
- Always power off the device before opening it.
- Take photos before disconnecting any cables so you remember where each connector goes.
- Work on a clean, well-lit surface to avoid losing small screws.
- If the phone is under warranty, contact Tecno service centre first.
Final Words
We hope this guide helped you solve the tecno pova 4 lcd backlight problem problem. If the issue persists after following all the steps, the problem may require a board-level repair or component replacement. Visit a professional mobile repair technician in that case. For more repair guides like this, browse our full repair library or subscribe to our YouTube channel for daily video tutorials.
